Steel Journal

GI Pipe Sizes: Inches, DN and Outside Diameter

Read GI pipe sizes in inches and DN, find the outside diameter in mm, and see how wall thickness changes the bore in ASTM A53 Schedule 40 pipe.

Nov 19, 2026Tianjin Huaqi Steel

A GI pipe’s inch size is a nominal designation, not the diameter you can measure with a caliper. In the ASTM A53 Schedule 40 series, 1-inch pipe is DN 25 with an outside diameter of 33.4 mm, while 2-inch pipe is DN 50 with an outside diameter of 60.3 mm. GI pipe is a common name for galvanized steel pipe; the applicable pipe standard determines its dimensions.

Back to blog
IN THIS ARTICLE

GI pipe size chart in inches and millimetres

This chart uses nominal dimensions from the ASTM A53 Schedule 40 examples in Wheatland Tube’s standard-pipe data. The wall column applies to this schedule, not to every pipe with the same nominal size.

GI pipe size chart in inches and millimetres
Nominal size (NPS) DN Outside diameter (mm) Nominal wall (mm)
½ in 15 21.3 2.77
¾ in 20 26.7 2.87
1 in 25 33.4 3.38
1½ in 40 48.3 3.68
2 in 50 60.3 3.91

NPS means Nominal Pipe Size. DN is the corresponding nominal designation; its number is not the measured outside diameter in millimetres. Converting 2 inches to 50.8 mm therefore does not give the OD of NPS 2 pipe.

Outside diameter, inside diameter and wall thickness

Pipe cross section showing outside diameter OD and single wall thickness t
Pipe cross section showing outside diameter OD and single wall thickness t

Cross-section, not to scale. OD spans the outside of the pipe. The symbol t marks one wall.

The outside diameter (OD) runs from one outer edge to the opposite outer edge through the centre. The inside diameter (ID) runs across the opening. The wall contributes thickness on both sides, so a nominal ID can be calculated as:

Inside diameter ≈ outside diameter − 2 × nominal wall thickness

For NPS 2 in the table, 60.3 − 2 × 3.91 = 52.48 mm, or about 52.5 mm. This is a nominal inside-diameter calculation. It is not a measured bore or a guaranteed minimum clearance.

For the same NPS 2 example, Schedule 80 retains a 60.3 mm OD but has a 5.54 mm nominal wall, with a smaller nominal bore of 49.3 mm in the cited table. See the Schedule 40 vs Schedule 80 comparison for more on how the schedules differ.

Is there one standard pipe length?

No. The size designation does not determine the piece length. 6 m and 20 ft are different lengths: exactly 20 ft is 6.096 m, which is 96 mm longer than 6 m. At 100 pieces, the nominal total length differs by 9.6 m. The example is a unit conversion, not a statement about which lengths are available.

Technical reference: Wheatland Tube, Standard Pipe, tables for ASTM A53 Grades A and B, Schedule 40 and Schedule 80.

Related reading