Steel Journal

304 vs 316 Stainless Steel: What’s the Difference?

Compare 304 and 316 stainless steel by molybdenum content, resistance to pitting, weldability and the meaning of 304L and 316L.

Nov 19, 2026Tianjin Huaqi Steel

304 stainless steel and 316 are both austenitic stainless steels. The main difference is that 316 contains added molybdenum: ATI lists 2.00–3.00% by weight for its ASTM A240 Type 316 flat product. Molybdenum improves resistance to localized corrosion, particularly pitting and crevice corrosion in chloride-containing environments. It does not make 316 corrosion-proof.

Back to blog
IN THIS ARTICLE

304 and 316 side by side

304 and 316 side by side
Feature 304 316
Alloy family Austenitic chromium–nickel stainless steel Austenitic chromium–nickel–molybdenum stainless steel
Molybdenum Not a required alloying addition in the 304 grade designation 2.00–3.00% by weight in ATI’s Type 316 ASTM A240 product data
Chloride pitting Less resistant than 316 in a like-for-like comparison More resistant, but still susceptible under sufficiently aggressive conditions
Low-carbon variant 304L 316L
Identification Appearance is not a reliable way to distinguish it from 316 Appearance is not a reliable way to distinguish it from 304

These points describe the grades, not the properties of every finished part. Surface condition, welds, crevices and the environment affect in-service behaviour.

What does molybdenum actually change?

Stainless steels resist corrosion because a thin passive film forms on their surface. Chlorides can break down that film locally. Pitting creates small localized cavities, while crevice corrosion develops in shielded gaps such as beneath a gasket or between overlapping surfaces. Molybdenum helps 316 resist both forms of attack better than 304 under comparable conditions.

PREN, or pitting resistance equivalent number, is a composition-based comparison index. One common formula is %Cr + 3.3 × %Mo + 16 × %N, with all inputs in mass percent. For two hypothetical alloys with the same chromium and nitrogen, adding 2.0 percentage points of molybdenum increases the computed index by 6.6 points. This illustrates the formula; it is not a measured difference between all 304 and 316 sheets.

PREN does not tell you how long a part will last or give a safe chloride concentration. Temperature, pH, deposits, surface finish and the presence of crevices change the conditions. Coastal air and continuous seawater immersion are not the same exposure.

What does the L mean in 304L and 316L?

The L denotes a low-carbon variant. Reducing carbon reduces the tendency for chromium carbides to precipitate during welding-related heating. This helps preserve corrosion resistance near grain boundaries. It does not eliminate the separate effects of welding procedure, surface treatment or the service environment.

The two distinctions answer different questions: 304 vs 316 describes the alloy family and the addition of molybdenum; standard vs L describes the low-carbon variant. L does not stand for a higher molybdenum content.

Are the grade names enough to identify the material?

No. The grade designation and product standard belong together. ASTM A240/A240M covers stainless plate, sheet and strip in its scope; a bar or pipe is not automatically supplied to that same flat-product standard. Colour or finish cannot positively identify composition. A material test certificate linked to the piece’s heat number provides traceable material identification.

Technical references: ATI Type 316 technical data; Outokumpu’s corrosion-resistance guidance and PREN equation; ASTM A240/A240M, scope.

Related reading