2D is a dull mill finish, 2B is a smoother mill finish, BA is bright annealed, and No. 4 is mechanically polished with a visible directional grain. These finish codes describe the sheet’s surface. They do not identify whether the underlying steel is 304, 316 or another grade.
IN THIS ARTICLE
Stainless steel sheet finishes at a glance
| Finish | How the surface is made | What to look for |
|---|---|---|
| 2D | Cold rolled, heat treated and pickled | Duller and less smooth than 2B |
| 2B | Cold rolled, heat treated and pickled, then lightly rolled | Smooth mill finish without the intentional abrasive grain of No. 4 |
| BA / 2R | Cold rolled and bright annealed | Brighter, more reflective mill surface |
| No. 4 | Mechanically polished with abrasives | Fine directional lines rather than an even mill appearance |
Scroll horizontally to read all columns
BA is a common term for bright annealed; 2R is used for the cold-rolled bright-annealed finish in EN terminology. Surface finish names do not establish an exact gloss or measured roughness by themselves. A specific limit or comparison sample supplies a more precise reference.
How to match two pieces
Place the offcuts next to each other and use one light source. Tilt both pieces together. A mechanically polished face with directional lines will look different when one piece is rotated. That is why two No. 4 panels can look mismatched even if they have the same finish code: the grain may run in different directions, or the surfaces may have been polished differently.
For a mill finish, compare the reflection on the actual surfaces rather than using a product photo taken at a different angle. If the exact finish sought is 2B on grade 304, the 304 stainless steel 2B finish guide explains that label in more detail.
Is bright annealed the same as mirror polished?
No. Bright annealing preserves the bright cold-rolled surface through the heat treatment. A mirror-polished finish is made by mechanically refining the surface until it gives a highly distinct reflection. Both can look shiny in a photo, but their production routes and reflected image are different. For an adjacent panel or a replacement part, use the finish code and compare the actual appearance instead of relying on the word “shiny.”
Technical references: Outokumpu, Surface Finishes brochure, cold-rolled and polished finish tables; Outokumpu Deco finish documentation.
