Steel Journal

304 vs 304L Stainless Steel: What Does the L Change?

See how 304 and 304L differ in carbon content, why that matters after welding, and how to read a dual-grade 304/304L marking.

Nov 21, 2026Tianjin Huaqi Steel

The L in 304L stands for low carbon. In Outokumpu’s Type 304/304L data sheet, the listed carbon limits are 0.08% maximum for Type 304 and 0.030% maximum for Type 304L by mass. Both are austenitic stainless steels. The practical difference is that the lower carbon limit reduces the risk of intergranular corrosion after welding or other exposure that can cause chromium carbides to form.

Back to blog
IN THIS ARTICLE

304 and 304L at a glance

304 and 304L at a glance
What to compare Type 304 Type 304L
UNS designation S30400 S30403
Carbon maximum in the cited data sheet 0.08% 0.030%
Austenitic stainless steel family Yes Yes
Typical reason to distinguish the two The material is specified as Type 304 The design or service specifies the lower carbon grade, particularly where welding makes sensitization relevant

The values are limits, not test results. A measured carbon value of 0.025% is below both listed limits; it therefore does not identify the certified grade on its own. A measured value of 0.050% is below the cited 304 maximum but above the 304L maximum. These comparisons only check carbon and say nothing about the other grade requirements.

Why welding makes the low-carbon grade useful

When susceptible stainless steel spends enough time in a temperature range that favors carbide precipitation, chromium carbides can form around grain boundaries. Chromium in the immediately surrounding metal can be depleted. This is called sensitization. In a corrosive environment, those depleted regions can be more susceptible to intergranular attack. Less carbon reduces this risk; it does not eliminate every cause of corrosion or make all welding procedures equivalent.

How to read 304/304L on one record

A dual designation means the material is certified to both grades under the standard indicated on its documentation. It is not a third alloy grade. Check the product specification and the certified mechanical properties as well as the chemistry. Do not substitute based on the carbon figure alone: minimum mechanical requirements can differ by grade and product form.

The L suffix is a carbon distinction, not the same comparison as 304 versus 316, which involves a different alloy composition.

Technical references: Outokumpu, Type 304/304L data sheet, Chemical Composition table; Outokumpu, Core Range Datasheet, Chemical Composition and Corrosion Resistance sections.

Related reading