Galvanized steel and galvannealed steel differ in the coating. On continuously coated sheet, galvanized steel has a predominantly zinc coating. Galvannealed steel is reheated after hot dipping, so iron from the steel diffuses into the zinc and forms a zinc–iron alloy coating. That extra heat treatment changes the surface and how the sheet behaves during painting, bending and spot welding.
IN THIS ARTICLE
Galvanized vs galvannealed at a glance
| Feature | Galvanized sheet | Galvannealed sheet |
|---|---|---|
| Coating composition | Predominantly zinc | Zinc–iron alloy; approximately 9–12% iron in the coating as a whole in GalvInfo’s technical description |
| Usual appearance | Metallic zinc surface; the amount of visible spangle varies | Dull, matte grey |
| Painting | Zinc surface requires preparation compatible with the paint system | The alloy surface promotes paint adhesion; it still needs preparation appropriate to the paint system |
| Forming | Softer zinc coating; surface behaviour depends on tooling and deformation | Harder, more brittle coating; deformation can produce fine coating particles known as powdering |
| Resistance spot welding | Welds using a suitable procedure for the zinc-coated sheet | Generally better spot-welding characteristics than a predominantly zinc coating; settings still depend on the assembly |
Scroll horizontally to read all columns
The iron percentage above describes the metallic coating, not the steel sheet. Iron concentration varies through the coating thickness. The number is an explanation of the material, not an acceptance limit.
How the coating changes
Both products start with steel strip passing through a molten zinc bath. For galvannealed sheet, the strip goes through a second heating step. The zinc reacts with iron from the steel at the interface and forms zinc–iron intermetallic layers. This alloyed surface is usually matte. Appearance is a clue, but it cannot establish the coating mass or composition.
The comparison here is about continuously coated steel sheet and coil. It is not a comparison with batch hot-dip galvanizing, in which a fabricated item is dipped after fabrication.
What changes when the sheet is painted or formed?
The texture of the zinc–iron surface helps paint adhere. Whether the paint system requires cleaning, pretreatment or primer depends on the surface treatment and the paint system. Galvannealed sheet is not the same as prepainted steel: the grey alloy coating is metallic, not paint.
During bending or stamping, galvannealed coating can crack and shed fine particles. This is called powdering. It refers to the coating; it does not mean that the steel sheet itself has split. The distinction matters when examining a formed part. Tooling, lubrication, coating thickness and deformation affect the amount of powdering, so the material name does not establish a universal pass or fail limit.
Does one coating always resist corrosion better?
No. Compare the coating, paint system, exposure and details such as cut edges together. Galvannealed sheet is commonly painted after fabrication. A comparison on a painted panel does not establish how the same two coatings will perform unpainted in a different environment.
Is Z275 the same as galvannealed?
No. Z275 identifies a zinc-coating designation, not a zinc–iron alloy coating. Likewise, ASTM A653/A653M covers both zinc-coated and zinc–iron-alloy-coated steel sheet; citing the standard alone does not identify which coating is present. See what Z275 and G90 mean for the separate question of coating-mass designations.
Technical references: ASTM A653/A653M, scope; GalvInfoNote 1.3, Galvanneal – Differences from Galvanize, revision 1.4, September 2018.
