Steel Journal

Z275 vs G90: Zinc Coating Mass, Units and Standards

Z275 and G90 describe total zinc coating mass on both faces. Compare their units, test basis and limits without confusing coating class with steel grade.

Nov 14, 2026Tianjin Huaqi Steel

Z275 and G90 describe closely corresponding zinc coating mass classes for continuously hot-dip galvanized steel sheet: Z275 specifies a minimum triple-spot average coating mass of 275 g/m² and G90 0.90 oz/ft², total both surfaces. They are not steel grades, and neither number is the coating on each side. The product standard, steel grade and coating test basis remain separate requirements; similar coating mass does not make two complete specifications interchangeable.

Back to blog
IN THIS ARTICLE

Z275 vs G90 at a glance

Z275 vs G90 at a glance
Property Z275 G90
Coating mass unit Grams per square metre Ounces per square foot
Minimum triple-spot average coating mass 275 g/m² 0.90 oz/ft²
Surface basis Both surfaces combined Both surfaces combined
Does it specify steel strength? No No
Is it a per-side thickness guarantee? No No

The unit conversion of 0.90 oz/ft² is approximately 275 g/m². This explains the correspondence, but not every requirement in two different standards is interchangeable. Triple-spot averages and individual-spot limits must be assessed according to the applicable standard and edition. These labels are not promises that every measurement at every location will equal the nominal designation.

Why the coating number does not finish the specification

The description “G90 galvanized coil” still leaves the base-steel grade unresolved. A forming application needs a grade with the required ductility; a structural part needs the specified mechanical properties. Coating class alone establishes neither. Similarly, a Z275 designation may appear with a European grade and standard, whereas an ASTM product has its own complete grade designation and requirements.

Corresponding coating masses do not establish that two steel grades are interchangeable. A material substitution requires comparison of mechanical properties, tolerances, coating requirements and testing, together with the applicable engineering approval.

For galvanized coil, the base steel and zinc coating describe different parts of the product. A general catalogue listing does not establish the properties or certification of a specific batch.

Do not divide the coating into an assumed guaranteed thickness

Dividing 275 g/m² by two produces a useful arithmetic average, not a guarantee of equal mass on each face. Converting mass to micrometres also introduces assumptions about coating density and distribution. A minimum coating requirement on each face needs a separate measurement and acceptance basis.

A sheet coating designation should not be copied directly into a specification for fabricated items galvanized after manufacture. The relevant product, galvanizing process and acceptance standard can be different. The applicable process is part of that distinction.

Properties not defined by the coating designation

The following properties remain separate from the zinc coating class:

  1. Product standard and edition, full steel grade and inspection document.
  2. Coating test basis and any additional per-face requirement.
  3. Base-metal or total coated thickness, width and applicable tolerances.
  4. Surface appearance, treatment, oiling and compatibility with later painting or bonding.
  5. Coil inner diameter, coil mass and edge condition.
  6. Identification and inspection arrangements for the material.

Batch-specific evidence is recorded in the mill certificate and inspection record, which must correspond to the coil identification.

Which standard governs the designation?

Use the designation required by the project's applicable standard. If the drawing calls for ASTM A653/A653M, retain the appropriate ASTM grade and coating requirements. If it calls for an EN product specification, retain its grade and coating designation. Do not mix a convenient coating abbreviation with an unrelated base-steel description.

Neither label alone predicts a fixed outdoor service life. Exposure, moisture retention, fabrication damage and the complete coating system matter. Coating class alone cannot establish a service-life value.

Related reading