Calculation method
Calculate theoretical steel mass from the selected cross section, dimensions, length and density. Choose plate, round bar, round tube or rectangular hollow section.
What this calculator helps you check
Read the quantities that matter
- AreaA · m²
- Mass per aream/A · kg/m²
- Mass per piecem · kg
- Total massΣm · kg
Compare dimensions, keep the calculation
Add rows to compare alternatives, switch between metric and imperial units, then copy the results or download a CSV with the input dimensions.
Formula
Cross-sectional area multiplied by length gives volume. Multiplying that volume by the entered density gives mass; quantity multiplies the mass of one piece.
m = b × L × t × ρ × 10⁻⁶; Σm = m × nHow to use it
- Use consistent units
Choose the unit system and enter the actual dimensions.
- Dimensions and assumptions
Choose a shape, enter its dimensions and quantity, and use the displayed density or enter your own.
- Check the result
Review the formula and its assumptions before using the result. Copy or download results with their units and assumptions.
Worked example
Follow one set of dimensions from inputs to calculated results.
Inputs
- Width
- 1,000 mm
- Length
- 2 m
- Wall or plate thickness
- 2 mm
- Density
- 7,850 kg/m³
- Quantity
- 1
Density is an explicit assumption in this example. Use the value appropriate to your material.
Calculation results
- Area
- 2 m²
- Mass per area
- 15.7 kg/m²
- Mass per piece
- 31.4 kg
- Total mass
- 31.4 kg
A 1000 mm wide, 2 mm thick plate of length 2 m has a volume of 0.004 m³. At 7850 kg/m³ it weighs 31.4 kg theoretically.
Limits
7850 kg/m³ is an editable structural-steel estimating value, not a measurement of every grade. Ideal sections omit rounded corners, coatings, welds and tolerances.
Frequently asked questions
No. Delivered net mass is measured. Geometry, density, manufacturing variation and any included packaging affect the comparison.
It displays the assumed density beside the result. A nominal carbon-steel example can use 7,850 kg/m³; a specific alloy can use its documented value.
No. Nominal dimensions, section rounding, tolerances and coatings can change the measured mass.
Continue with a related calculation
Check your own dimensions
Use your actual measurements in the calculator above. Review the units and assumptions before using the result.
