All toolsRebar Weight Calculator

Inputs

Units
1/100

Enter decimals with a dot, without thousands separators (3.6, not 3,6).

Row 1

m/L = πd² × ρ × 10⁻⁶/4

Formula uses mm, m and kg/m³ where applicable. Imperial inputs are converted before calculation.

Add rows to calculate several pieces at once.

Rebar Weight Calculator by Nominal Diameter

Use nominal bar diameter, length, quantity and density to estimate rebar mass in kg or lb and weight per metre or foot.

Calculate

Calculation method

Calculate a nominal circular-section rebar mass estimate from diameter, length, density and bar count.

What this calculator helps you check

Read the quantities that matter

  • Mass per lengthm/L · kg/m
  • Mass per piecem · kg
  • Total massΣm · kg

Compare dimensions, keep the calculation

Add rows to compare alternatives, switch between metric and imperial units, then copy the results or download a CSV with the input dimensions.

Formula

The calculation uses a circular area based on the entered nominal diameter. At 7850 kg/m³, mass per metre is approximately 0.00616538d² with d in mm.

m/L = πd² × ρ × 10⁻⁶/4

How to use it

  1. Use consistent units

    Choose the unit system and enter the actual dimensions.

  2. Dimensions and assumptions

    Enter nominal diameter, bar length and quantity to calculate a theoretical result using the shown density.

  3. Check the result

    Review the formula and its assumptions before using the result. Copy or download results with their units and assumptions.

Worked example

Follow one set of dimensions from inputs to calculated results.

Inputs

Diameter
20 mm
Length
2 m
Density
7,850 kg/m³
Quantity
1

Density is an explicit assumption in this example. Use the value appropriate to your material.

Calculation results

Mass per length
2.4661502 kg/m
Mass per piece
4.9323005 kg
Total mass
4.9323005 kg

For nominal diameter 16 mm and density 7850 kg/m³, the circular-section estimate is approximately 1.57834 kg/m.

Limits

This is not a model of individual ribs or a determination of standard compliance. Confirm the relevant rebar specification and permitted mass variation separately.

Frequently asked questions

No. A nominal-diameter estimate requires the designated nominal diameter. An over-rib measurement is not automatically equivalent to nominal diameter.

Use the nominal diameter designated for the bar, not a caliper reading across ribs as a substitute.

No. Compare measured mass or certified nominal mass with the applicable standard and product specification.

Check your own dimensions

Use your actual measurements in the calculator above. Review the units and assumptions before using the result.