Calculation method
Estimate tightly wound strip length from coil outside diameter, inside diameter and strip thickness.
What this calculator helps you check
Read the quantities that matter
- LengthL · m
Compare dimensions, keep the calculation
Add rows to compare alternatives, switch between metric and imperial units, then copy the results or download a CSV with the input dimensions.
Formula
In the ideal annular cross section, strip length times thickness equals annular area. Thus L=π(D²−d²)/(4000t) when diameters and thickness are in mm and length is in m.
L = π(D² − d²)/(4000t)How to use it
- Use consistent units
Choose the unit system and enter the actual dimensions.
- Dimensions and assumptions
Enter outside diameter, inside diameter and strip thickness. Use dimensions measured on the same coil.
- Check the result
Review the formula and its assumptions before using the result. Copy or download results with their units and assumptions.
Worked example
Follow one set of dimensions from inputs to calculated results.
Inputs
- Outside diameter
- 1,200 mm
- Inside diameter
- 508 mm
- Wall or plate thickness
- 2 mm
Calculation results
- Length
- 464.14518 m
OD 1000 mm, ID 500 mm and thickness 2 mm give an ideal strip length of 294.524311 m.
Limits
No winding gaps, interleaving or varying thickness are included. Inside diameter is the inner boundary of the strip, not the core's external packaging size.
Frequently asked questions
This geometric length method divides annular area by strip thickness. Width cancels, and no mass-to-volume conversion is used.
It defines the core opening. Only the annular area between inside and outside diameters contains strip.
The geometry assumes constant thickness and tight winding. Loose wraps and nonuniform coil shape affect the actual length.
Continue with a related calculation
Check your own dimensions
Use your actual measurements in the calculator above. Review the units and assumptions before using the result.
