Calculation method
Compare two uniform rectangular cutting grids to estimate how many identical parts fit on a rectangular sheet.
What this calculator helps you check
Read the quantities that matter
- Number of partsn
- Columnsnx
- Rowsny
- Material utilizationη · %
- Rotationθ · °
- Part width in layoutbp · mm
- Part height in layouthp · mm
Compare dimensions, keep the calculation
Add rows to compare alternatives, switch between metric and imperial units, then copy the results or download a CSV with the input dimensions.
Formula
The tool checks the original orientation and a 90° rotation of every part, then selects the grid with the larger count. Kerf separates neighbouring parts.
nx = floor[(b + k)/(bp + k)]; ny = floor[(h + k)/(hp + k)]How to use it
- Use consistent units
Choose the unit system and enter the actual dimensions.
- Dimensions and assumptions
Enter the usable sheet width and height after subtracting edge allowances, then enter part size and kerf. Enable 90° rotation to compare both uniform orientations.
- Check the result
Review the formula and its assumptions before using the result. Copy or download results with their units and assumptions.
Worked example
Follow one set of dimensions from inputs to calculated results.
Inputs
- Width
- 2,000 mm
- Height
- 1,000 mm
- Part width
- 300 mm
- Part height
- 200 mm
- Kerf
- 3 mm
The example allows 90° rotation and compares uniform grids, not mixed nesting.
Calculation results
- Number of parts
- 27
- Columns
- 9
- Rows
- 3
- Material utilization
- 81 %
- Rotation
- 90 °
- Part width in layout
- 200 mm
- Part height in layout
- 300 mm
A 1000 × 1000 mm usable sheet with 300 × 200 mm parts and zero kerf fits 15 parts in either uniform orientation, using 90% of sheet area.
Limits
It is not a global nesting optimiser: mixed orientations, irregular parts, grain direction and tooling paths are excluded. Reserve any edge-trim or perimeter-cut allowance by entering the usable sheet size.
Frequently asked questions
No. A mixed-orientation or specialist nesting layout may fit more. This tool is a transparent two-grid comparison, not a guarantee of optimum yield.
No. It compares two regular grid orientations, not arbitrary nesting or mixed piece sizes.
Yes. Use the permitted orientation if finish or rolling direction prevents rotating the part.
Continue with a related calculation
Check your own dimensions
Use your actual measurements in the calculator above. Review the units and assumptions before using the result.
